wheel teaser
#1
wheel teaser
i know being on the reciving end sucks but when your on the giving end its so much more funn
got my wheels in today 17x8s i should have them mounted and hopefully on the car saturday if not deff on sunday
got my wheels in today 17x8s i should have them mounted and hopefully on the car saturday if not deff on sunday
#3
Well I put the wheels on today.. ill post pics later... but I'm upset .... I now need to lower the front and rear 2 more inches I don't have the coil wrenches and I tried with a screwdriver the lower nuts move but the uppers that rest againstt the spring is a pita.. and the other problem is one of the center caps is not for these wheels
#4
17x8 tsw doningtons orderd them while at waterfest for $635 including shipping and the lug nuts....with 225/45/17s (i got all 4 tires for 150 with a couple thousand miles) i will switch to a 225/40/17 when these tires are bad
before pics
after pics
car sits way to high and just cruising around i feel the hight diffrence its like 2inches
before pics
after pics
car sits way to high and just cruising around i feel the hight diffrence its like 2inches
Last edited by StormUnite; 08-08-2010 at 11:29 PM.
#7
i know bri is one of them.... and wider ehhh no need this is my beater the camaro is what i go wide with .... in the rear any who lol
and i plan on lowering it more... i didnt expect these wheels to raise it up 2inches like it did but as i said i cant get that damn adjuster nuts to move i tried with a screw driver but its a pita and i dont have the wrenches the h&rs came with got any other ideas? should i just spray the **** out of it with pb blaster n use the screw driver and a hammer?
and i plan on lowering it more... i didnt expect these wheels to raise it up 2inches like it did but as i said i cant get that damn adjuster nuts to move i tried with a screw driver but its a pita and i dont have the wrenches the h&rs came with got any other ideas? should i just spray the **** out of it with pb blaster n use the screw driver and a hammer?
Thread
Thread Starter
Forum
Replies
Last Post