Snub mount bolt wont go back in
#13
GOT IT!
I went back out today with my lone 13mm combo wrench w/ ratcheting closed end.
It looked the 1st couple threads of the nut (or whatever) were slightly damaged. When I put the bolt in and spun the threads didn't catch. So, I put the nut in, put the closed end of the wrench on the head, and pressed on the head of the nut.
I pressed on the head of the nut until it backed into something and while I still had pressure on it I just spun the sh** out of it until it caught. The first couple threads must've been damaged because it was stiff at first but after I got it started it was smooth again.
#WIN!
As a side note, if I ever have to replace that snub mount again I'm taking the front end off so I don't have to undo that nut!
Thanks for the replies guys-
I went back out today with my lone 13mm combo wrench w/ ratcheting closed end.
It looked the 1st couple threads of the nut (or whatever) were slightly damaged. When I put the bolt in and spun the threads didn't catch. So, I put the nut in, put the closed end of the wrench on the head, and pressed on the head of the nut.
I pressed on the head of the nut until it backed into something and while I still had pressure on it I just spun the sh** out of it until it caught. The first couple threads must've been damaged because it was stiff at first but after I got it started it was smooth again.
#WIN!
As a side note, if I ever have to replace that snub mount again I'm taking the front end off so I don't have to undo that nut!
Thanks for the replies guys-