NickBroderick's Timeline.
#442
alex: you'll rly hate your ride height next weekend lol. can't wait to see you guys there.
nic do you still have that screw that holds the fender liner right above the tire? that maybe your culprit or just do some trimming. mark the area you think is rubbing with permanent marker and go for a drive. then take a look at where you're missing ink and trim that part
nic do you still have that screw that holds the fender liner right above the tire? that maybe your culprit or just do some trimming. mark the area you think is rubbing with permanent marker and go for a drive. then take a look at where you're missing ink and trim that part
#443
Yu I just had to look where I was missing paint hahaha. I could roll about another inch or so because it seems to be rubbing more towards the back end of the fender, I'll do that today or tomorrow at Baby K's. Maybe I'll try and get it as FLAT AS POSSIBLE, but unless I do a slight pull, I think I'm just going to rub until my tire is worn down enough. Lol.
Alex, get those hydros and install them this week, you can tow your slammed car to H2o.
Alex, get those hydros and install them this week, you can tow your slammed car to H2o.
#444
I went and got my car inspected, err rejected, today and lulz were had.
I guess I'll let the picture do the talking...
I was loling until I got in my car and started driving home, then I noticed I was scraping a bit more than usual which worried me. I got home and looked under my car...
And that's when the lulz stopped. I changed my oil today and while I was doing that I attempted to hammer that back into place. It worked somewhat but it's still bent. I'm hoping I can bottom out soon and smoosh it back into place, I don't want it getting caught on anything.
Also my skidplate has been taking a BEATING. So much so that it now has two holes in it, I've lost 6 of the screws holding it into place and it has bent one of the two main screws so bad that I have to reinsert it at an angle.
You can't tell from the picture but the bottom left screw hole has been mashed in about a half an inch. The washer for that screw is now bent too, so I hope that doesn't get caught on anything.
The perks of being low I guess...
I guess I'll let the picture do the talking...
I was loling until I got in my car and started driving home, then I noticed I was scraping a bit more than usual which worried me. I got home and looked under my car...
And that's when the lulz stopped. I changed my oil today and while I was doing that I attempted to hammer that back into place. It worked somewhat but it's still bent. I'm hoping I can bottom out soon and smoosh it back into place, I don't want it getting caught on anything.
Also my skidplate has been taking a BEATING. So much so that it now has two holes in it, I've lost 6 of the screws holding it into place and it has bent one of the two main screws so bad that I have to reinsert it at an angle.
You can't tell from the picture but the bottom left screw hole has been mashed in about a half an inch. The washer for that screw is now bent too, so I hope that doesn't get caught on anything.
The perks of being low I guess...
Last edited by NickBroderick; 09-21-2010 at 07:04 PM.