Motor removal/Front clip removal
#52
Woow that does stick out far. Look at my pics. Mine was only half that. You have to grind down the nose with a different pilot bearing. Read this thread I made.
https://www.audiforums.com/forum/sho...=160359&page=3
These guys helped a lot ..Kudos to them.
https://www.audiforums.com/forum/sho...=160359&page=3
These guys helped a lot ..Kudos to them.
#53
The insert is finally out. I tried a blind hole bearing puller with a slide hammer, but this did not work. I drilled the insert out to 11/16 and taped the hole with a 3/4-16 tap. Then I used a threaded rod with a nut welded on the end and the impact gun. Came out in 2 seconds.
Thread
Thread Starter
Forum
Replies
Last Post