been gone for a while-new projekt in the works
#11
the Aqua blue is replacing the Cobalt blue, however i am having a difficult time digging up the paint code from the paint store, so i may have to go with Cobalt if i can't get it. Either one would look good IMO.
#13
a few more updates from this weekend.
a quick pic of the garage. its trashed.
got the s4 skirts on friday and fitted/trimmed them up.
Got the car down to my roomates Dad's shop so that he could weld up the trim holes for me
doin some weldin
all welded up and began grinding. the grinder flattened out some spots a little, so i will have to use filler to build up the areas where grinding was done.
this week i will finish grinding down the welds, fill the doors and then begin pulling the fenders
a quick pic of the garage. its trashed.
got the s4 skirts on friday and fitted/trimmed them up.
Got the car down to my roomates Dad's shop so that he could weld up the trim holes for me
doin some weldin
all welded up and began grinding. the grinder flattened out some spots a little, so i will have to use filler to build up the areas where grinding was done.
this week i will finish grinding down the welds, fill the doors and then begin pulling the fenders
#17
last night while waiting for some filler to dry i decided to tackle one of the front fenders
i also pulled the passenger front fender last night/this morning. it is not AS smooth as the drivers side turned out, so i'll be tackling it with a hammer and dolly to get it as good as possible before laying mud.
so far its an inch wider on each side
i also pulled the passenger front fender last night/this morning. it is not AS smooth as the drivers side turned out, so i'll be tackling it with a hammer and dolly to get it as good as possible before laying mud.
so far its an inch wider on each side
#18
Wow! I didn't know you were actually going to pull those out, literally!
I thought you were talking about adding couple inches with welding some plates.
Regardless, it's looking great though. Are you planning to shave those Audi logo on the front fenders and the side markers or are you keeping those on?
I thought you were talking about adding couple inches with welding some plates.
Regardless, it's looking great though. Are you planning to shave those Audi logo on the front fenders and the side markers or are you keeping those on?