Fault code P1335 help!!
#11
RE: Fault code P1335 help!!
ORIGINAL: DurTTy
are you sure there are no other codes stored in there? you should get it cleared and see what happens to it then go ahead and wait till epc comes on again.
btw the max tq /mx boost exceeded happened to me when i cranked up my MBC past the program limits of my flash. i cleared those codes and they never came back
are you sure there are no other codes stored in there? you should get it cleared and see what happens to it then go ahead and wait till epc comes on again.
btw the max tq /mx boost exceeded happened to me when i cranked up my MBC past the program limits of my flash. i cleared those codes and they never came back
I'm headed there tomorrow to get re-flashed. I've seen boost spikes of 21 PSI and vac drops of 30 in. hg...
I don't think that's too common on a 91-93 GIAC x-file flash...
Funny thing is when I hit 21 PSI the car is pulling oh so sweet.
EPC and P1335 will come on when I'm just cruising around going easy on it, or right before the onset of boost.
It really makes no sense to get an over boost/torque code when your not even boosting/"torqueing"!
Very frustrating! [>:]
#16
RE: Fault code P1335 help!!
After getting re-flashed P1335 and the EPC light were back to their old routine.
So, I ordered a MBC... So far so good! It's set at 9 clicks and holding steady at 15 psi.
The onset of boost is MUCH smoother and holds a helluva lot longer (kinda how a MBC should work ya know).
No codes/EPC light since the install, but we'll see how good it really works.
I'll give an update in a week, and let you guys know if I have any codes or what have you.
I really hope this does the trick!
So, I ordered a MBC... So far so good! It's set at 9 clicks and holding steady at 15 psi.
The onset of boost is MUCH smoother and holds a helluva lot longer (kinda how a MBC should work ya know).
No codes/EPC light since the install, but we'll see how good it really works.
I'll give an update in a week, and let you guys know if I have any codes or what have you.
I really hope this does the trick!
Thread
Thread Starter
Forum
Replies
Last Post