Hello All

Has anyone here have experience with carbon fiber stickers? I am thinking of wrapping my interior door handles in the stuff to cover up the wear and gouges in the rubber. From what I've seen on the 'net, replacing the handles is a pretty daunting task.I was also considering doing the fuel fillercover as well, apparently the stuff can last for up to five years outside...my car is now silver with black trim so thefiller covermay look good in carbon?

 

seems tacky to me. Think there are covers you can by for the handles. Leave the fuel cover be

 

cool - covers would be fine as long as I don't have to remove the handles to install them. If I end up removing the handles then I might as well replace them with new ones...

 

i was going to do my interior door handles with this: http://www.slymachines.com/catalog/products.asp?catid=8

i wouldn't use the fake carbon fiber stickers that you can get at autozone or where ever that is just a decal. this is supposed to be real fiber weave. i think it would look ok if done well and is much cheaper than the carbon fiber handles from osir.

 

I tryed to do it i could not get ti to form to the handle without ******* up it was a disaster..and i tinted my windows perfectly...so idk

 

there's carbon fiber lay-overs. i remember cutting out "C E L IC A" and inserted it in the rear of my old car. looked cool i guess.

p.s. - i'd take out the center caps on your stock 6's

 

Thanks for the link twenty8red, that looks like what I'll go with.

The fuel filler cover will NOT be done, I agree with Cincy that it would look bad after all.

...and no center caps? I was expecting the shop to paint them all black but I thought they did a good job with the detailing...I'll give it a few weeks to see if it grows on me or not, I can always pop them off

 

who needs center caps

 

other than it being green I think this is a better picture of what your car looks like:

 

should have done the center caps the opposite way.