o2 Sensor, DIY
#21
RE: o2 Sensor, DIY
Ok Cool sounds good. Thoes links were very helpful by the way, i actually have never taken off all of the engine covers, but i found them both now its just a matter of having the time to take of the y-pipe and get to it! But yeah i can't wait for the DIY!
#22
RE: o2 Sensor, DIY
trrapped- here is a pic of the angle to use to get to passenger side o2 sensor. i didn't have to take the y-pipe off for this side. and a pic of the o2 wrench. i taped it so it wouldn't fall into the engine. by the way, were you able to see the driver's side o2 sensor on the exhaust manifoldwhen you removed the coolant tank?
[IMG]local://upfiles/22553/C4C5861D71DA40EA9A07BB6F45108B37.jpg[/IMG]
[IMG]local://upfiles/22553/4C1BDDCAAD9B456D96DB0F2E7825D4D7.jpg[/IMG]
[IMG]local://upfiles/22553/C4C5861D71DA40EA9A07BB6F45108B37.jpg[/IMG]
[IMG]local://upfiles/22553/4C1BDDCAAD9B456D96DB0F2E7825D4D7.jpg[/IMG]
#23
RE: o2 Sensor, DIY
Not yet, i located the wireing to them and saw the general area of where they are, i havnt been able to do anything because its like 10 degrees here and i dont feel like working yet, but in the 1st pic is that where you put the wrench way back there?
#26
RE: o2 Sensor, DIY
Ok, 1 not a stupid question i was thiniking the same thing.... If you have a check engine light and you get an error code p1113 or p1131 you need to replace the first two. (these are the ones i'm in the process of doing. I would say if your going to do one of the sensor 1's (pre-cat) to do them both because their hard and once done you most likly will not have to change them again. Also sensor 2 (post-cat) are really simple to get to and you can see them clearly from under the car!
If you want to do one at a time you could, but why not do them both because you'll know exactly what to do! Then again thats just my opinion
If you want to do one at a time you could, but why not do them both because you'll know exactly what to do! Then again thats just my opinion
#30
RE: o2 Sensor, DIY
Hey, that is the sensor! Right?
I hope you can see what im talking about, but how in the world are you able to put a new one in the hole it you cant reach down there, what tool or toold do you use?