Headlights fixed - a way to keep using a bad combi switch
#11
What you can do is add the wires as described above and run them to a switch under the dash. If your headlight switch is good, leave the under-dash switch off. If/when it melts, flip the switch to close the jumper and you'll have lights again. Alternately, put pigtail wires with blade terminals on the parking and low beam wires behind the headlights. If the switch melts, plug them in to jump them and continue driving.
Thread
Thread Starter
Forum
Replies
Last Post
j_v_z
General Tech
1
10-20-2013 09:41 PM
ImTheDevil
DIY - Do It Yourself
0
01-31-2012 04:48 PM