I just ordered my borla exhaust 140100. The instructions online say not to use air tools to put it on... is that advice I should follow? It is just so much easier..

 

They probably say that so that the joints/sleves dont sieze where the clamps get put on so you can take it off if you ever need to. If I were you Id have flanges welded onto the piping wherever it connects in seperate pieces.

 

I was going to do it myself but I think I might just take it to the nearest shop on the Borla website. think thats a good idea?
I think the closest is in Shrewsbury.. called Keystone Massachusetts