2003 Audi RS6
Daytona Gray
Black leather interior
Carbon Fiber Interior Trim
Navigation

second owner
103,500 miles
full timing belt service completed at 95k miles (this would be the third timing belt service)
new water pump, thermostat, seals (main seal, camshaft seals, valve cover)
transmission fully serviced at 93k miles as were all of the diffs using redline fluids
new front rotors and pads at 89k miles
just replaced passenger side outer CV joint
car does not leak anything. my garage floor thanks this!

exterior condition - 8 out of 10. some small chips, but overall in great condition
interior condition - 8 out of 10, normal audi rubberized coating wear. no wear on the leather seats. they are in excellent condition

Modifications -

Exterior
Euro upper and lower grilles (matte black)
All Audi emblems were replaced with matte black ones
Black painted headlights with silver corner bulbs
ECS Tuning Smooth Clear Side Markers
Hella Smoked Rear Tail Lights

Interior
Black Weathertech floormats

Drivetrain
Eurocharged ECU flash - secondary o2 sensors and SAI system coded out
MTM TCU flash
Twin Forge 007p valves
All vacuum tubing have been replaced with black silicone tubing
Wagner SMIC kit (stock fog lights deleted)
VenAir black hose kit
Milltek Non-Resonated RS6 exhaust with black tips
Stern Race Engine Mounts with sensor bypass
034 SAI block off plates with SAI system completely removed
Apikol Race Durometer Diff Mount
034 Billet PCV
Bosch 044 Fuel Pump with billet aluminum fuel filter using AN fittings and hose
Secondary radiators were removed

Suspension
KW V2 Coilovers (complete DRC system removed, just installed)
034 race top strut mount (just installed)
Hotchkis Sway Bar Kit (rear is setup on aggressive, just installed)
Black Forest 15mm spacers all around with extended lug bolts
Black VMR 19x9.5 wheels with 265/30r19 Michelin Pilot Super Sport (4k miles on this setup)
Black Audi center caps

additionally, will include the following parts I've gathered for a 01e manual swap -
clutch pedal
shift box and linkage
slave cylinder and tubing
01e transmission with mounts
front axles

it's not a complete kit, but most of the major parts are there.

please email me or text me at 224-595-08three1

will not part anything. sorry

 

Any pics?